Peavey X-Monitor - Manual (Page 53)

Mute controller
I)GO
Each press of this switch increments the Sequenced Mutes by one, the display (B) will
reflect this. Also used to activate the displayed Scene when an Up/Down (A) button
was used to scroll to a new Scene. In this case, an "*" will be displayed as the first
character in the display to indicate that the displayed number is not currently the
active Scene. Pressing GO will put that displayed Scene into place and clear the "*"
from the display.
NOTE: All of the above actions will take place, but the displayed Sequenced Scene
will not be active (mutes not enabled) unless the Sequence Scene switch (G) is lit.
Each press of these switches increments or decriments the Patch Display (B). Holding
either button down will allow quickly scrolling up or down.The buttons are also used
to select the parameters and settings of the system while in Utility mode.
p. 53
Microprocessor control 4