Panasonic DMC-GH2 - Manual (Page 132)

VQT3A36
132
Recording
• Refer to P94 for details.
• Set to [ON] to display the [EXPO.METER] when correcting exposure,
performing Program Shift, setting aperture, and setting shutter speed.
• Unsuitable areas of the range are displayed in red.
• When [EXPO.METER] is not displayed, switch the display information
for LCD monitor/viewfinder by pressing [DISPLAY]. (P63)
• The [EXPO.METER] disappears after approximately
4 seconds if no operation is performed.
Setting items for each [REC] Mode
• You cannot switch between LCD monitor and viewfinder by pressing [LVF/LCD] when it is set to
[SWITCH BY PRESSING THE LVF/LCD BUTTON].
• [EXPO. SETTINGS] is disabled when you set [AUTO SWITCH] in [LVF/LCD SWITCH] to [OFF].
[PREVIEW HOLD]
This will set the operation of the [ ] button when displaying the
preview screen.
[OFF]: Preview screen is displayed only when the [ ] is
pressed.
It will return to previous screen when [
] is released.
[ON]: Preview screen is displayed even after the [ ] is
released after pressing. (P95)
It will return to previous screen when [
] is pressed
again.
[CONSTANT PREVIEW] [OFF]/[ON]
[EXPO.METER]
Select whether or not to display the exposure meter when the mode dial is
switched to
³ / ± / ´ / ² etc.
[OFF]/[ON]
[EXPO. SETTINGS]
Change the method of Exposure Compensation setting switching
when the mode dial is set to
, , and .
[SWITCH BY PRESSING THE REAR DIAL] :
Press the rear dial to switch between Exposure Compensation,
Program Shift, aperture setting, and shutter speed setting.
[SWITCH BY PRESSING THE LVF/LCD BUTTON] :
Press [LVF/LCD] to switch between Exposure Compensation,
Program Shift, aperture setting, and shutter speed setting.
³ Program Shift Exposure Compensation
± Aperture Exposure Compensation
´ Shutter speed Exposure Compensation
² Shutter speed Aperture
or
DMC-GH2H&GH2K&GH2PP-VQT3A36_eng.book 132 ページ ２０１０年１０月１９日 火曜日 午前１１時３分