Panasonic DMC-GH2 User Manual
Page 59
59
VQT3A36
Basic
•
The brightness of the pictures displayed on the LCD monitor is increased so some subjects
may appear differently from actuality on the LCD monitor. However, this does not affect the
recorded pictures.
•
The LCD monitor automatically returns to standard brightness after 30 seconds when recording
in [MODE1]. Press any button to make the LCD monitor bright again.
•
If the screen is difficult to see because of light from the sun etc. shining on it, use your hand or
another object to block the light.
•
The number of recordable pictures decreases in [AUTO] and [MODE1].
•
[AUTO] is only available in the Recording Mode.
•
[AUTO] is disabled during motion picture recording.
•
When the menu screen is displayed in a dark environment etc., the LCD monitor becomes
darker even if [LCD MODE] is set to [MODE2].
•
The initial setting when using the AC adaptor (DMW-AC8PP; optional) is [MODE2].
•
Press the shutter button halfway or turn the camera off and on to cancel [SLEEP MODE].
•
[SLEEP MODE] is set to [5MIN.] in the Intelligent Auto Mode.
•
[SLEEP MODE] is fixed to [2MIN.] when [AUTO LCD OFF] is set to [15SEC.] or [30SEC.].
•
Press any button to turn on the LCD monitor again.
•
Since [ECONOMY] is canceled when the eye sensor auto switching is performed, it is
recommended to use this mode with [AUTO SWITCH] in [LVF/LCD SWITCH] (P133) set to
[OFF].
•
[SLEEP MODE] does not work in the following cases.
–
When using the AC adaptor
–
When connecting to a PC or a printer
–
When recording or playing back motion pictures
–
During a slide show
[LCD MODE]
The brightness of the LCD monitor can be adjusted depending on
how bright it is around the camera.
„ [AUTO]:
The brightness is adjusted automatically depending on how bright
it is around the camera.
[MODE1]:
Make the LCD monitor brighter.
[MODE2]:
Set the LCD monitor to the standard brightness.
[MODE3]:
Make the LCD monitor darker.
q [ECONOMY]
You can conserve the battery life by setting these menus.
Also, it will turn off the LCD monitor automatically when not in use
to prevent discharge of the battery.
p [SLEEP MODE]:
The camera is automatically turned off if the camera has not been
used for the time selected on the setting.
[OFF]/[1MIN.]/[2MIN.]/[5MIN.]/[10MIN.]
[AUTO LCD OFF]:
The LCD monitor is automatically turned off if the camera has not
been used for the time selected on the setting.
[OFF]/[15SEC.]/[30SEC.]
LCD
…
1
…
2
…
3
DMC-GH2H&GH2K&GH2PP-VQT3A36_eng.book 59 ページ ２０１０年１０月１９日 火曜日 午前１１時３分