Pioneer DV-353 - Manual (Page 14)

Connecting Up 02
14
En
• Before unplugging the player from the
power outlet, make sure you first switch
it into standby using either the front
panel
STANDBY/ON button, or the
remote control, and wait of the -OFF-
message to disappear from the player’s
display.
• For the above reasns, do not plug this
player into a switched power supply
found on some amplifiers and AV
receivers.
Using other types of video
output
This player has standard (composite), S-
Video and component video outputs. The
main difference between them is the quality
of the picture. S-Video delivers a better
picture than standard composite video, while
component video gives better picture quality
still. The variety of outputs also gives you the
flexibility of connecting your particular
equipment using the best connection type
available.
Connecting using an S-Video
output
You can use the S-Video output instead of the
VIDEO OUT jack to connect this player to
your TV (or other equipment).
1 Use an S-Video cable (not supplied)
to connect the S-VIDEO OUTPUT to an
S-Video input on your TV, monitor or
AV receiver.
Line up the small triangle above the jack
with the same mark on the plug before
plugging in.
DIGITAL AUDIO OUT
S
L
R
P R
P B Y
COAXIAL
OPTICAL
COMPONENT VIDEO OUT
AUDIO OUT
VIDEO OUT
TV
S-VIDEO
INPUT
Connecting using the component
video output
You can use the component video output
instead of the
VIDEO OUT jack to connect
this player to your TV (or other equipment).
1 Use a component video cable (not
supplied) to connect the COMPONENT
VIDEO OUT jacks to a component video
input on your TV, monitor or AV receiver.
DIGITAL AUDIO OUT
S
L
R
P R
P B Y
COAXIAL
OPTICAL
COMPONENT VIDEO OUT
AUDIO OUT
VIDEO OUT
TV
COMPONENT
VIDEO IN