Pioneer Video Card PDA-5002 - Manual (Page 9)

9
En
Installation and Connections
English
Installation and Connections
Connection to a personal
computer
Connection method differs depending on the computer
type. When connecting, please thoroughly read the
computer’s instruction manual.
Before making connections, be sure to make sure that
the personal computer’s power and display’s main power
is off.
For the PC input signals and screen sizes that the display
is compatible with, please refer to the plasma display’s
Operating Instructions.
Connection of separate SYNC analog RGB
source
Make separate SYNC connections for a personal
computer that has RGB output separated into 5 output
signals: green, blue, red, horizontal synchronization signal,
and vertical synchronization signal.
When connecting to INPUT2
G B R HD VD
(ON SYNC) (H/V SYNC)
Ô 75 2.2
Ω k Ω
INPUT2
When using INPUT2, set the impedance selector switch
to match the output impedance of the connected
computer’s synchronization signal.
When the output impedance of the computer’s
synchronization signal is above 75
Ω, set this switch to
the 2.2 k
Ω position.
On-screen setup is necessary after connection.
Please see pages 14 and 15.
Connection of composite SYNC analog RGB
source
Make composite SYNC connections for a component
with output that has the vertical synchronization signal
layered on top of the horizontal synchronization signal.
When connecting to INPUT1
On-screen setup is necessary after connection.
Please see pages 14 and 15.
When connecting to INPUT2
When using INPUT2, set the impedance selector switch
to match the output impedance of the connected
component’s synchronization signal.
When the output impedance of the component’s
synchronization signal is above 75
Ω, set this switch to
the 2.2 k
Ω position.
On-screen setup is necessary after connection.
Please see pages 14 and 15.
Notes
÷ When making composite SYNC connections, do not connect
anything to the VD jack. If connected to, the picture may not
be displayed properly.
÷ On some types of Macintosh ® components, G ON SYNC and
composite SYNC are both output. With this type of
component, please connect using the G ON SYNC connection
(as shown left).
G B R HD VD
(ON SYNC) (H/V SYNC)
Ô 75 2.2 Ω k Ω
INPUT2
ANALOG RGB (ANALOG RGB)
INPUT1
OUTPUT