Panasonic SC-BTX70 EN - Manual (Page 24)

24
RQT9464
Listening to the Radio
Up to 30 stations can be set.
1 Press [RADIO] to select “FM”.
This unit: Press [RADIO/EXT-IN].
2 Press [STATUS] to select the position to start the
auto preset search.
Each time you press the button:
LOWEST (factory preset):
To begin auto preset with the lowest frequency (FM 87.50).
CURRENT:
To begin auto preset with the current frequency.*
* To change the frequency, refer “Manual tuning” (B right).
3 Press and hold [OK].
Release the button when
“AUTO” is displayed.
The tuner starts to preset all the stations
it can receive into the channels in
ascending order.
≥“SET OK” is displayed when the stations are set, and the radio
tunes to the last preset station.
≥“ERROR” is displayed when automatic presetting is
unsuccessful. Preset the stations manually (B right).
1 Press [RADIO] to select “FM”.
2 Press the numbered buttons to select the channel.
To select a 1-digit number
e.g., 1: [1] > [OK].
To select a 2-digit number
e.g., 12: [1] > [2]
Alternatively, press [W, X] or [2, 1].
When a stereo FM broadcast is being
received, “ST” lights in the display.
≥The FM setting is also shown on the TV display.
∫ If noise is excessive
When FM is selected
Press [AUDIO] to display
“MONO”.
Press the button again to cancel
the mode.
≥The mode is also cancelled when you change the frequency.
≥This setting can be preset for each broadcasting station. When
“MONO” appears follow procedures 1 and 2 in “Presetting
stations manually” (> below).
1 Press [RADIO] to select “FM”.
2 Press [SEARCH
6] or [SEARCH5] to select the
frequency.
≥Main unit: Press [:/6, 5/9] to select the
frequency.
≥When a radio broadcast is
being received, “T” lights in
the display.
≥To start automatic tuning,
press and hold [SEARCH6, SEARCH5] (main unit:
[:/6, 5/9]) until the frequency starts scrolling.
Tuning stops when a station is found.
∫ Presetting stations manually
Up to 30 stations can be set.
1 While listening to the radio broadcast
Press [OK].
2 While “P” is flashing on the display
Press the numbered buttons to select a channel.
To select a 1-digit number
e.g., 1: [1] > [OK].
To select a 2-digit number
e.g., 12: [1] > [2]
A station previously stored is overwritten when another station is
stored in the same channel preset.
The unit can display the text data transmitted by the radio data
system (RDS) available in some areas.
If the station you are listening to is transmitting RDS signals,
“RDS” will light up on the display.
While listening to the radio broadcast
Press [DISPLAY] to display the text data.
Each time you press the button:
PS: Program service
PTY: Program type
OFF: Frequency display
* “M.O.R. M”=Middle of the road music
Setting up the radio
Presetting stations automatically
OK
EXT-IN
RADIO
STATUS AUDIO
SEARCH SEARCH
1 2 3
4 5 6
7 8
0 9
DISPLAY
abc def
jkl mno
tuv
ghi
qrs
p
xyz w
SEARCH
SEARCH
Numbered
buttons
RADIO
AUDIO
DISPLAY
STATUS
,
OK
Listening/confirming the preset channels
Manual tuning
RDS broadcasting
PTY displays
NEWS VARIED FINANCE COUNTRY
AFFAIRS POP M CHILDREN NATIONAL
INFO ROCK M SOCIAL A OLDIES
SPORT M.O.R. M* RELIGION FOLK M
EDUCATE LIGHT M PHONE IN DOCUMENT
DRAMA CLASSICS TRAVEL TEST
CULTURE OTHER M LEISURE ALARM
SCIENCE WEATHER JAZZ
RDS displays may not be available if reception is poor.
ST
T MONO
T MONO
NOTE
Radio
SC-BTX70EGEB-RQT9464-B.book 24 ページ ２００９年４月９日 木曜日 午後２時５３分