Panasonic SC-BTX70 EN - Manual (Page 40)

40
RQT9464
Wireless connections (optional)
By connecting 1 or 2 units of the optional Panasonic wireless system SH-FX70 with 2 or 4 optional Panasonic speakers
SB-HSX70, it is possible to change this unit into a 4.1 ch or 6.1 ch home theatre system.
This system's surround sound effect settings will change (> 15) and it is possible to listen to the true, original surround audio
signals of the playback contents. (However, the centre channel included in the audio source will be output from the front L R
speakers.)
∫ Wireless setup diagram
e.g., 4.1ch
e.g., 6.1ch
LS: Surround (left), RS: Surround (right)
≥Place behind the seating position, about 1 m higher than ear
level.
LS: Surround (left), RS: Surround (right)
≥Place on the side of the seating position.
LB: Surround back (left), RB: Surround back (right)
≥Place behind the seating position, about 1 m higher than ear
level.
∫ Digital transmitter
1 Push $ to open the digital transmitter door.
2 Insert fully until you hear a click.
∫ Wireless system
∫ AC mains lead
Connecting the surround, surround back speakers (SB-HSX70) and the optional
wireless system (SH-FX70)
LS RS
LS
LB RB
RS
Main unit
(with the digital
transmitter)
Seating position
Surround speaker cables
Main unit
(with the digital
transmitter)
Seating position
Surround speaker cables
SH-FX70: 1 unit
SB-HSX70: 1 set
SH-FX70: 2 units
SB-HSX70: 2 sets
Preparation
Preparation
≥Turn off all equipment before connection and read the appropriate operating instructions.
≥Connect the AC mains lead after all other connections are complete.
≥Do not use the wireless system and digital transmitter in a metal cabinet or bookshelf.
≥Place the wireless system within approximately 15 m from the home theatre unit. NOTE
Connections
Do not insert or remove while the home theatre unit is on.
SH-TR70 digital transmitter
Push!
SPEAKERS
ENCEINTES
LS / RB LB / RS
SURR I/D SET
AC IN
SURROUND (3 – 6 )
AMBIOPHONIQUES L SIDE R SIDE
SURR
L
SIDE
R
SIDE
SURR
L
SIDE
R
SIDE
Surround
selector
Connecting the speakers to the wireless system
Connect to terminals of the same colour.
Insert fully.
Speaker cable
For 4.1ch connection
SURROUND (LS): Blue
SURROUND (RS): Grey
For 6.1ch connection
SURROUND (LS): Blue
SURROUND BACK (LB): Grey
SURROUND (RS): Grey
SURROUND BACK (RB): Blue
Selector setting for
the left and right
speakers
Selector setting for
the left speakers
Selector setting for
the right speakers
Impedance: 3 ≠ to 6 ≠
Speaker input power: 100 W
(Min)
AC mains lead
To household mains socket
Optional speaker
settings
SC-BTX70EGEB-RQT9464-B.book 40 ページ ２００９年４月９日 木曜日 午後２時５３分