Panasonic TU-HDT206A - Manual (Page 17)

Operating Instructions
TU-HDT206A
17
6.4 Power Saving Setup
Automatic Off Timer function requires a time to
be set for the automatic shutdown of the digital
receiver. The time which is set is the period
from the last received command sent to the
receiver until when the digital receiver will
automatically go into the standby mode. The
default setting is 6 hours. The setting can be
changed to 4 or 8 hours or OFF. Select OFF if
digital receiver is connected to a VCR or DVD
recorder as a tuner.
6.5 Tuning Menu
Signal Display
The signal strength and signal quality are shown
as separate bars. For the digital receiver to
function correctly, both these bars need to be
displayed in green colour. If either of the bars is
displayed in the orange colour, there may be
video and audio reception problems (see
Troubleshooting). If either of the bars is
displayed in red colour, there is a problem with
the reception of the digital signal and the
antenna and connection to the digital receiver
need to be checked by a qualified antenna installer. See Troubleshooting on page
22.
Channel Installation
When the receiver is initially set up, the channel tuning is initiated by selecting the
“Auto Channel Search” function.
Auto Channel Search
Auto Channel Search provides the easiest way
to conduct a channel search. It does not require
you to enter any other information. This function
is strongly recommended for regular users.
However, the user should be aware that all
existing channels will be removed as soon as
you confirm start of auto scan.
In the Auto Channel Search OSD, all channels
found will be listed. The channel search may
take a few minutes.
If you exit an auto scan during the scan process, some channels may not be
available to you.