Panasonic TU-HDT206A - Manual (Page 5)

Operating Instructions
TU-HDT206A
5
2.2 Rear Panel
AC Power Mains: 220 to 240 V; 50 / 60 Hz
RF IN: For connection to cable from outdoor terrestrial antenna.
RF OUT: For connection to your TV antenna IN or Video Recorder RF IN.
S-VIDEO: Y/C video for connection to standard definition TV or Video Recorder.
VIDEO: Composite video output for connection to TV, Video Recorder or other A/V
Receiver.
AUDIO: Two sets of stereo audio outputs for connection to TV, Video Recorder or
other A/V Receiver.
YPbPr: Y/Pb/Pr component video for connection to high definition display.
RGB (15pin D): R/G/B/HS/VS video for connection to high definition display.
COAXIAL: Digital Audio output by coaxial for connection to AV processor.
OPTICAL: Digital Audio output by optical for connection to AV processor.
HDMI: Digital video and audio output for connection to high definition display.
USB Port: For software system maintenance (covered by sticker).
2.3 Box Contents
The box that contains your digital receiver should also contain the following items:
Remote Controller and batteries (AA Size)
RCA video cables (one white / red, and the other cable red / green / blue)
RF cable
User’s Manual with Warranty Information
3 The Remote Controller
3.1 Preparing the Remote Controller
1). Remove the cover of the battery compartment (on the back of the handset) by
pushing the tab back and then lifting.
2) Insert 2 AA (1.5 V) batteries according to the + and – markings indicated inside
the battery compartment.
3) Replace the cover.
Test the remote controller by pressing any key and check if the IR-LED (Red) on the
front panel of the receiver flashes.
3 2
2 x “AA”
Batteries
1