Panasonic TU-HDT206A - Manual (Page 19)

Operating Instructions
TU-HDT206A
19
To Update Manually
Perform “Viewer Prompt To Update”.
Access the on screen display. Press OK to set the digital receiver to start searching
for the OAD immediately. All video and audio is stopped for several minutes while the
updating sequence is in progress.
Note: Recommended method is to use “Update Automatically”.
USB Software Upgrade
The operating software of the digital receiver can also be upgraded via a USB port.
The USB port is located on the rear of the receiver and is covered by a sticker. The
new software has to be loaded on a USB flash drive. The flash drive is plugged in to
the USB port and the software is automatically loaded when the digital receiver is
switched on. Please follow the displayed instructions.
6.6 Diagnostic Information
From here, you can get general information
about the digital receiver including the serial
number ID, software version and hardware
version.
7 Teletext Operation
Teletext is only available on certain broadcast
channels. The time taken to display the pages
and sub-pages is set by the teletext transmitter.
Teletext is also used for Closed Captioning of
television programmes for the hearing
impaired. Closed captions can be found on
Teletext Page 801. The picture remains on the
screen while you type in 801.
Some broadcast stations will have a message
on the screen to tell you that closed captions
are not available for this programme. Some broadcast stations give you no indication
at all.
TOP (Table of Pages) MODE
In TOPTEXT mode, the red button moves to the previous page number and the green
button moves to the next page number. The yellow and blue buttons correspond to
different subjects. Pushing the coloured button can access these subjects. This is the
current preferred method of operation in Australia.
Red /Green / Yellow / Blue buttons
In TOP TEXT mode these correspond to the differently coloured subjects.