Pioneer DV-440 - Manual (Page 8)

8
En
Before Using
Preparing the Remote Control
Inserting batteries into the remote
control
1
While pushing the tab on the battery
compartment cover
toward the center
of the remote, pull
out in the direction
indicated by the
arrow.
2
Insert batteries.
Make sure to match
the plus (+) and minus
(–) polarity guides on
the batteries with the
marks inside the
battery compartment.
3
Close the cover.
Checking Accessories
Please confirm that the following were received with the
player.
Audio cord
Video cord
Power cord
Remote control unit
AA (R6P) dry cell batteries
When disposing of used batteries, please comply
with governmental regulations or environmental
public instruction’s rules that apply in your country
or area.
H048 En
Operating instructions (this manual)
RANDOM
PROGRAM
SEARCH MODE
0
9
8
7
+10
6
5
4
CLEAR
3
2
1
1
REV
FWD
¡
PLA
Y 3
P AUSE
8
STOP
7
e
STEP/SLOW
E
NEXT ¢
PREV
RETURN REPEA
T
CONDITION MEMOR
Y
LAST MEMOR
Y
ANGLE
SUB TITLE
AUDIO SETUP
MENU
TOP MENU
DISPLA
Y
¶
5 ∞
3
2
Î
¶
OPEN/ CLOSE REPEA
T
A-B
¶ ¶
5 5
5
5
E N T E R
4
¶
¶
30
30
7m (23 feet)
Notes
• Do not mix old and new batteries.
• When replacing batteries, use all new batteries.
• When not using the remote control for a long period of time
(over 1 month), remove the batteries to avoid possible
damage from battery corrosion. If battery leakage occurs,
wipe the battery liquid from the battery component, then
insert new batteries.
Remote control operation
When operating the remote control, point it at the
remote sensor (
Î) located on the player’s front panel.
The remote control can be used up to 7 m (23 feet) from
the player and within a 30° angle on each side of the
sensor.
Notes
• Exposing the remote sensor to direct sunlight or strong light
may cause faulty operation.
• If the CONTROL IN jack on the player’s rear panel is
connected to the CONTROL OUT jack of another
component, point the remote control at the other
component to operate the player. Operation will not be
possible when pointed at this player (page 16).