Panasonic AJ-HPX2000 - Manual (Page 134)

134 Connection with external device : Connection with external devices using the USB 2.0 port
8. MODEL
This section indicates the model of the P2 card that
originally contained data on the partition.
‹ Note
Press the cursor button ( !) to switch to the PARTITION
NAME. Press the [ "] button to return to the original
model name display.
Enter the PARTITION NAME from the software
keyboard by selecting [CHANGE PARTITION NAME]
in the OPERATION MENU while the thumbnail of the
hard disk drive is displayed. (Max. 20 characters)
9. DATE/TIME
This section indicates the date and time the data on
the partition was recorded.
10. SERIAL
This section indicates the serial number of the P2 card
that originally contained the data on the partition.
11. VERIFY
This section indicates the verification setting and
results at the time the data on the partition was
recorded.
ON:FINISHED :
Verification was performed and the results agreed.
ON:FAILED :
Verification was performed and the results did not
agree.
OFF :
No verification was performed.
- - - :
No verification information is available.
‹ Notes
z Even for a FAT-type hard disc drive, the 1001st or
later clips are not shown.
z For a FAT-formatted hard disc drive, the information
about only the first partition is shown.
z For a P2 STORE (AJ-PCS060G) that has an invalid
partition, that partition information is shown in gray.
12. NAME
This section indicates the PARTITION NAME.
1
Switch the mode to USB HOST.
For more information, see [
Switching to the USB
HOST mode ] (page 132).
2
Connect the hard disc drive via USB.
3
Press the thumbnail button to display the thumbnail
screen.
4
Press the MENU button and select HDD >
EXPLORE from the thumbnail menu. The display
provides a screen that shows the information about
the hard disc drive.
5
From the menu, select OPERATION > FORMAT
(HDD) and select YES using the cursor buttons and
SET button. Then, the confirmation message is
displayed again. Select YES.
6
The camera-recorder starts formatting the hard disc
drive. Once formatted, the hard disc drive can be
treated as a TYPE-S HDD.
‹ Note
Formatting a hard disc drive erases all contents of it.
Note that you cannot erase the contents of certain
partitions by specifying them.
Formatting a hard disc drive
AJ-HPX2000P(VQT1D27-1)E.book 134 ページ ２００７年７月３０日 月曜日 午後１時３１分