Panasonic AJ-HPX2000 - Manual (Page 87)

87 Adjustments and Settings for Recording : Handling data
A
d
ju
stm
ents and S
e
tti
ngs f
o
r
Rec
o
rdi
n
g
1
Navigate the menu to the <SD CARD READ/WRITE>
screen.
2
Turn the JOG dial button to move the cursor to the
menu option [R. SELECT]. Then, press the dial
button.
3
Turn the JOG dial button to select a desired number
(1 - 8). Then, press the dial button.
4
Turn the JOG dial button to move the cursor to the
option [READ].
5
Press the JOG dial button to display the following
message:
6
Turn the JOG dial button to move the cursor to YES.
Then, press the dial button.
When the data has been read, the following message
appears:
The data will not be read if any of the following messages
appears when the JOG dial button is pressed:
7
To exit the menu, press the MENU button.
The settings menu will be replaced by status
indications for the unit.
To read data on an SD memory card
To select a file number
< SD CARD READ/WRITE >
# R.SELECT 1
READ
W.SELECT 1
WRITE
CARD CONFIG
TITLE READ
TITLE:
1: ******** 5: ********
2: ******** 6: ********
3: ******** 7: ********
4: ******** 8: ********
To read data on a selected file
< SD CARD READ/WRITE >
R.SELECT :1
# READ
W.SELECT :1
WRITE
CARD CONFIG
TITLE READ
TITLE:
1: ******** 5: ********
2: ******** 6: ********
3: ******** 7: ********
4: ******** 8: ********
READ?
YES
# NO
Error message Remedy
READ NG
NO CARD
(No SD memory card inserted.) Insert an SD memory card.
READ NG
FORMAT ERROR
(SD memory card not properly
formatted.) The card has not been
formatted using the unit.
Replace the card.
READ NG
NO FILE
(No file found.) Write file data.
READ NG
ERROR
(SD memory card not
readable.) Only data written with the unit
is readable.
READ NG
CANNOT ACCCESS
(SD memory card not
accessible.) Example: The SD memory card
is not accessible because it is
being played back.
After the operation in process,
read data.
READ OK
AJ-HPX2000P(VQT1D27-1)E.book 87 ページ ２００７年７月３０日 月曜日 午後１時３１分