Patton electronic ForeFront 3125 - Manual (Page 29)

Model 3125 installation 29
Model 3125 RAS Getting Started Guide 2 • Hardware installation
6. Carefully slide the 3125TM into the chassis until it engages the mid-plane (see figure 9), when that hap-
pens, pivot the injection/ejection handles into locked position (see figure 10). Verify that the red tab in
each handle clicks into place, indicating that the module is fully seated and locked.
Figure 9. 3125RC and 3125TM installation diagram
Figure 10. Locking an injection/ejection handle