Patton electronic ForeFront 3125 - Manual (Page 37)

Preparing the RAS for configuration 37
Model 3125 RAS Getting Started Guide 3 • Configuring the RAS for operation
– 8 bits
– No Parity
– 1 Stop bit
– No flow control
3. Set up HyperTerminal™ as follows:
– Open a HyperTerminal session.
– Enter a name for this connection.
– Click on the Connect using: pop-up menu and choose the Direct to ComX option (where X is the number
of the COM port onto which you connected the cable in step 1) (see figure 17).
Figure 17. Hyperterminal properties
– Configure the COM port settings as shown in figure 18.