Pitney Bowes ADDRESSRIGHTTM DA900 - Manual (Page 30)

4
Setting Up Your Printer
4-4 SV60970-OG Rev. A
You can install up to six inkjet cartridges in your printer.
Cartridges are held in place by vertical brackets on the inkjet
cartridge holder.
NOTE: You do not have to install cartridges in all positions to
run the printer. The number you install depends on your
addressing requirements.
Install the cartridges as follows:
1. Remove the inkjet cartridge from its packaging. Avoid
touching the copper contacts and gold printhead.
2. Remove protective tape from the printhead.
3. Lift the transport cover over the output area.
4. Lift the blue retaining lever above the inkjet cartridge
holder.
1. Position the side guide screw holes so they align with
the screw holes on the side guide block assembly. See
the picture below.
2. Insert the screws provided and tighten them so that the
side guides are firmly attached to the side guide block
assembly. You need a standard #2 Phillips head
screwdriver to do this.
5. Attach the Side
Guides to the
Printer
6. Install the Ink
Cartridges