Paradise RCP2-1000 - Manual (Page 29)

RCP2-1000 RM Remote Controller Operations Manual 203987 Rev A 29
4.1.9 RF Switch Fault
In Redundant mode, the SSPA always tracks position of RF switch(es). The user is
informed about the RF switch state through the front panel LCD and serial protocol. If
the switch position for any reason can't reliably be determined, the SSPA declares a
RF switch fault state.
4.1.10 Serial Connection Fault
If serial communication can't be reliably established with remote SSPA unit, RCP2-
1000 will declare Serial Connection fault condition. This condition set all major alarms
and the summary state to the fault state. In addition, front panel LCD will display "No
Connection!!" sign. The sign will automatically goes away if connection been success-
fully reestablished. Of course, this condition won't prevent user from browsing through
RCP2-1000 menus to observe last red parameters of the remote unit.