Panasonic DX-2000 - Manual (Page 198)

196
Replacing the Lithium Battery
During the initial self test, when the power is turned “On”, the machine will evaluate the condition of the clock
back up battery. If the battery is weak or fully discharged, the following message will be shown on the display.
To replace the battery, follow the procedure below:
(see Note 1)
1 (1) Turn the Power Switch to the “O” (OFF)
position.
(2) Open the ADF Door.
(3) Remove the Battery together with the
Battery Holder.
CAUTION
!
Dispose of the Lithium battery properly
and keep it away from small children.
2 Replace the Lithium Battery.
(Order No.: CR2032)
CAUTION !
When replacing the battery make sure to
observe the polarity to avoid damage to
the machine.
3 (1) Install the Battery Holder into the machine.
(2) Close the ADF Door.
(3) Turn the Power Switch to the “I” (ON)
position.
4 If the clock is flashing on the LCD Display, follow the procedure on page 36 to reset the clock.
1. The service life of the battery is approximately 1 year when the power to the machine is turned “Off”.
REPLACE BATTERY
INFO. CODE=026
3
2
1
2
Note:
Troubleshooting