Panasonic KX-P8420 - Manual (Page 106)

Chapter 6
106
Setup from the Front Panel and WebSetup
This chapter describes how to configure the printer’s Setup options. The
settings you specify in Setup determine user access to the printer, printing
defaults applied to jobs, and general system settings. Some Setup options
are specified during an initial Setup from the printer’s front panel; others
must be set later from Fiery WebSetup.
Initial Setup from the front panel
Initial Setup for network printing must be performed using the front panel.
After the initial Setup is complete, you must finish configuring Setup options
using Fiery WebSetup (see
page 112 ). Some options set from the front
panel can also be modified using Fiery WebSetup.
The general steps for performing Setup from the front panel are:
• Specify parallel port settings ( page 107 ).
• Specify network port settings ( page 107 ).
• Specify network protocol settings ( page 109 ).
Before you change any Setup options, it’s a good idea to print the current
configuration settings, in case you need to restore these settings later. For
information on printing a configuration page, see “Printing pages from the
front panel” on
page 47 .
Use the following procedure to access the Parallel Port Setup, Network Port
Setup, and Network Protocol Setup menus from the front panel.
To access Setup menus from the front panel:
1 Turn on the printer.
Wait until Ready or Ready(Sleep) is displayed.
2 Press the Menu/Exit button.
3 To advance through the options, press the Continue/
Forward button; to return to previous options, press the
Cancel/Left button.
4 To select an option, press the Enter button.
Repeat steps 3 and 4 to continue accessing other options.
5 To exit the Setup menus at any time, press the Menu/
Exit button.