Plantronics CT11 - Manual (Page 19)

37
TIPS
M
ORE
M
ORE
The digital security code is an identification
code used to connect the remote and the
base unit. Normally, setting the code is not
necessary. In the rare situation that you suspect
another cordless telephone is using the same
security code, you can change the code. To
change the digital security code, deregister
the code, then register a different code.
D E - REGISTER THE S ECURITY C ODE
1) Remove the remote from the base. In the
standby mode, press and hold DELETE
and END for about 10 seconds until you
hear a confirmation tone.
“De-Register?” appears.
2) Press ▲ to select “Yes”, then SELECT/CH.
You will hear a confirmation tone, and
“Deregistration Complete” appears.
If you have not
pressed any key
for 30 seconds
while in the de-
registering
operation, the
phone returns
to the standby
mode.
If you receive
an incoming
call, page, or
charge the
remote while in
de-registering
operation,
or press
TALK/FLASH
or END, the
operation is
canceled.
36
C
HANGING THE
D
IGITAL
S
ECURITY
C
ODE
R EGISTER THE S ECURITY C ODE
1) Unplug the AC adapter. Do not replace
the remote to the base.
2) Press and hold PAGE on the base, while
you plug in the AC Adapter, hold page
until the CHARGE/IN USE LED on the
base flashes.
3) Press TALK/FLASH. “Remote Registering”
appears. When the registration operation
is finished “Registration Complete”
appears and the CHARGE/IN USE LED is
no longer illuminated. You will hear a
confirmation tone and the phone returns
to the standby mode.
TIPS
You must
complete the
registration
operation within
30 seconds, or
the phone
returns to the
standby mode.
During the
registration
operation, you
cannot receive
an incoming call,
page, or make
a call.
CT11-12_020904 2/13/04 10:47 AM Page 36