Plantronics CT11 - Manual (Page 7)

13
B
A
SICS
S
ELECTING A
D
IFFERENT
C
HANNEL
If you encounter interference while using
your phone, you can manually change the
phone’s channel for clear operation. This
function works only when the phone is in use.
Press SELECT/CH. “Scanning” appears
on the display, indicating the phone is
changing to another channel.
To locate the
remote, press
PAGE on the
base. The
remote beeps
for 60 seconds,
and “Paging”
appears on the display.
Paging is canceled when pressing any key
on the remote or PAGE on the base.
Additionally, if you receive an incoming
call, PAGE is canceled.
If the remote
battery is
completely
drained, the
remote will not
beep when
paging.
TIP
12
TIP
T
ONE
D
IALING
S
WITCH
-
OVER
Some telephone
companies use
equipment that
require pulse dialing
(sometimes referred
to as rotary dialing).
If you need to enter
tone dialing digits,
you can switch-over to tone dialing during
the call. For example, entering your bank
account number after you have called your
bank.
Initially make your call with the pulse
dialing mode. Once your call connects,
press ✱/TONE. Enter the desired number.
These digits will be sent as tone dialing.
Once the call ends, the tone mode is
canceled and pulse dialing mode resumes.
The tone feature
only applies
when the dial
mode is set to
pulse.
A tone number
can be stored in
a memory
location. This is
referred to as
Chain Dialing.
(See page 25.)
During a call, as you begin to move your
remote too far from your base unit, static
increases. If you pass the range limits of the
base unit, your call will terminate within 30
seconds.
F
IND
R
EMOTE
T
RAVELING
O
UT
-
OF
-R
ANGE
CT11-12_020904 2/13/04 10:47 AM Page 12