Patton electronic SmartNode 4400 - Manual (Page 18)

SmartNode 4400 Series detailed description 18
SmartNode 4400 Series Getting Started Guide 1 • General information
SmartNode 4400 Series rear panels
The SmartNode 4400 rear panel ports are shown in figure 3 and described in table 3 on page 18.
Figure 3. SmartNode 4400 rear panels
Table 3. Port descriptions
Port Description
ETH 0/0 (WAN Ethernet 0/0 port) 10/100Base-Tx full-/half-duplex, RJ-45, auto detection and auto-
MDI-X connects the unit to an Ethernet WAN device (for example,
a cable modem, DSL modem, or fiber modem).
ETH 0/1 (LAN Ethernet 0/1 port) 10/100Base-Tx full-/half-duplex, RJ-45, auto detection and fall-
back, connects the unit to an Ethernet LAN.
Console (RS-232 control port) Used for service and maintenance, the Console port, an RS-232
RJ-45 connector with EIA-561 pinout, connects the router to a
serial terminal such as a PC or ASCII terminal (also called a dumb
terminal). Asynchronous default data rate 9600 bps, hardware
DSR and DTR signals for external modems are wired directly
together internally
FXS Ports (4400/JS models) For connection of up to 32 analog FXS devices (selectable for 12,
16, 24, or 32). Either a 50-pin or 64-pin RJ21X connector that
connects the router to an analog terminal (a telephone, for exam-
ple) FXO port. EuroPOTS support (ETSI EG201 188).
Model SN4432
44xx/JS/UI
100-240V
(50-60 Hz)
1 AMP
UNI T EQ UIPPED WITH DU AL SUPPL IES
DISCONNECT BO
TH SUPPLIES BEFORE SER VICING
ETH 0/0
Console
Telco P or ts
50
Reset
ETH 0/1
44xx/JS/48
Ethernet ports
Console port
Telco ports
36-72V
1.6 AMP
100-240V
(50-60 Hz)
1 AMP Telco Ports
100-240V
(50-60 Hz)
1 AMP Console Reset Console Reset ETH 0/0 ETH 0/1 ETH 0/0 ETH 0/1
Telco Ports Console Reset Console Reset ETH 0/0 ETH 0/1 ETH 0/0 ETH 0/1