Patton electronic SmartNode 4400 - Manual (Page 37)

1. Configure IP address 37
SmartNode 4400 Series Getting Started Guide 4 • Getting started with the SmartNode 4400 Series
Note The SmartNode CD-ROM contains a collection of third party software
tools (including TFTP servers and Telnet utilities) to help you configure,
operate and monitor the SmartNode device.þ
Connect to the RS-232 console port
The RJ-45 Console port is wired as an EIA-561, RS-232 port. Use the included Model 16F-561 adapter and
cable (see
figure 17 ) between the SmartNode’s Console port and a PC or workstation’s RS-232 serial interface.
Activate the terminal emulation program on the PC or workstation that supports the serial interface
(e.g. HyperTerm).
Figure 17. Connecting to the RS-232 Console port
Terminal emulation program settings:
• Asynchronous
• 9600 bps
• No parity
• 8 bit
• 1 stop bit
• No flow control
Console port
Laptop PC
Model 16F-561
adapter and cable
100-240V
(50-60 Hz)
1 AMP
UNIT EQ UIPPED WITH DU AL SUPPLIES
DISCONNECT BO
TH SUPPLIES BEFORE SER VICING
ETH 0/0
Console
Telco P or ts
50
Reset
ETH 0/1