Panasonic WJ-ND400 - Manual (Page 24)

Setting up the Rack
24
When connecting multiple extension units (WJ-HDE400) to the recorder, place the recorder in the center of the rack.
Connect the recorder and the extension unit with the connection cable (1 m {39.4 "}) included with the extension unit.
Note:
• Install the recorder in the center of the rack, if using a rack. If you install the recorder at the top or bottom of the rack, the cable may not be
long enough.
• When installing the recorder in the rack, leave a space of 1 unit (44 mm {1.73 "}) above and below each unit.
• Secure the connection cables to the extension unit using the cable clamp provided.
If the connection is poor, the system may become unstable and unable to record images.
• Keep the cables as short as possible. Looped cables or large distances between pieces of equipment may cause malfunctions. Also, do not
bend the cables more than 90º, wind the cables in a coil (10 cm {3.94 "} in diameter).
• Refer to the Setup Instructions (PDF file) to check the unit numbers of connected extension units.
Rack mounting positions
Extension unit
(unit number 4)
Connection cable
(provided with extension unit)
Requires 1 Unit
Extension unit
(unit number 5)
Extension unit
(unit number 1)
Extension unit
(unit number 3)
Requires 1 Unit
Requires 1 Unit
Requires 1 Unit
At least 10 cm
Cable coil example
Round cable coil
Requires 1 Unit
Extension unit
(unit number 2)
Network Disk
Recorder
ND400_Basic.book 24 ページ ２００８年４月８日 火曜日 午後３時５９分