Panasonic DMP-BDT350 - Manual (Page 14)

14
VQT2J87(ENG)
STEP 4 : Connecting to
an AC power
≥ This unit consumes a small amount of AC power (“Quick
Start”: “Off”, approx. 0.1 W) even when turned off. In the
interest of power conservation, if you will not be using this
unit for an extended period of time, it can be disconnected.
STEP 5 : Setting
After connecting your new player for the 1st time and pressing
the power button, a screen for the basic settings will appear.
Preparation
Turn on the television and select the appropriate video
input on the television.
1
Press [Í POWER].
Setup screen appears.
If this unit is connected to a Panasonic TV (VIERA)
supporting HDAVI Control 2 or later via an HDMI cable,
then the setting information on the TV is acquired by this
TV.
2
Follow the on-screen instructions and
make the settings with [3, 4] and press
[OK].
After completing “Easy Setting”, you can perform “Network
Easy Setting”.
≥ You can perform this setup anytime by selecting “Easy Setting” in the
Setup menu. ( > 33)
≥ Initial setting is set to “2ch (Downmix) + 5.1ch”, so you will need to select
“7.1ch” if using the 7.1ch output.
The unit should be installed near an accessible AC power
outlet, with the power cord connected directly to it.
To completely disconnect power from the unit, unplug the
power cord from the AC power outlet.
AC power supply cord
(included)
To a household AC outlet
Easy Setting
OK
RETURN
Analog Audio Output
Set unit’s analog audio output.
Select only “7.1ch” to enjoy audio from a
receiver through 7.1ch analog connections.
Otherwise, select “2ch (Downmix) + 5.1ch.”
2ch (Downmix) + 5.1ch
7.1ch
DMP-BDT300_VQT2J87_eng.book 14 ページ ２０１０年１月１８日 月曜日 午後５時２７分