Panasonic DMP-BDT350 - Manual (Page 16)

16
VQT2J87(ENG)
Network Easy Setting (Connection Check)
Network Easy Setting (Internet Connection Check)
≥ Refer to the operating instructions of the hub or router.
≥ You can perform this setup anytime by selecting “Network Easy Setting” in
the Setup menu. ( > 33)
≥ You can redo these settings individually using “Network Settings”. ( > 33)
≥ After performing network settings on this unit, the settings (encryption
level, etc.) of the Wireless router (Access point) might change. When you
have trouble getting online on your PC, perform the network settings on
your PC in accordance with the settings of Wireless router (Access point).
Display
Check the
following
1. LAN cable connection or
Connection to access point
: Fail
≥ Connection of
the LAN
cables (> 12)
2. IP address setting : Fail
3. Connection to gateway : Fail
1. LAN cable connection or
Connection to access point
: Pass
≥ Connection
and settings
of the hub and
router
≥ Settings of “IP
Address/DNS
Settings”
(> 33)
2. IP address setting : Fail
3. Connection to gateway : Fail
[BDT350]
1. LAN cable connection or
Connection to access point
:Pass
2. IP address setting
:Home
network
available
3. Connection to gateway :Fail
1. LAN cable connection or
Connection to access point
: Pass
2. IP address setting : Pass
3. Connection to gateway : Fail
Display Check the following
Cannot find the server.
(Error code: B019)
≥ “Primary DNS” and “Secondary
DNS” settings of “IP Address/
DNS Settings” (> 33)
Failed to connect to the
server.
(Error code: B020)
≥ The server may be busy or the
service may have been
suspended. Please wait a few
moments, and then try again.
≥ Settings of “Proxy Server
Settings” (> 33) and the router
OK
Network Easy Setting (Connection Check)
Yes No
Complete.
1. LAN cable connection
2. IP address setting
3. Connection to gateway
LAN cable is not connected.
Please check the connection.
Select “Yes” and press [OK] to check network
connection again. Select “No” and press [OK]
to finish Network Easy Setting.
: Fail
: Fail
: Fail
OK
Network Easy Setting (Internet Connection Check)
Complete.
- Connection to the Internet : Fail(Error code: B019)
Failed the connection test.
Cannot find the server.(Error code: B019)
Please refer to the operating instructions for the cause
of the error and the solution for it.
Press [OK].
DMP-BDT300_VQT2J87_eng.book 16 ページ ２０１０年１月１８日 月曜日 午後５時２７分