Panasonic AJ-D450 - Manual (Page 19)

– 19 –
Check the connections. (see previous page.)
Select [OFF] on ENCODER SEL at the set up menu. (See page 30.)
Select [ON] to operate the internal encoder externally.
Adjust the SYSTEM PHASE.
3-1
3-2
1
2
Adjust the connected P2 VTR in the same way.
4
3
On the P1 VTR, play back a cassette tape on which standard color bar signals
have been recorded.
Adjust P1 VTR SYS PHASE.
Adjust the controls to the following with the waveform monitor (WFM).
■ Waveform on waveform monitor
1)
2)
3)
4) Expand WFM 0.1
µ
s on the INT mode.
Check the H SYNC position.
In this status, select EXT mode for the WFM.
In EXT mode, adjust the SYSTEM PHASE to H, SC COARSE, SC FINE, in
this order, at the set up menu to set H SYNC to its previous position.
(Expanded to
0.1
µ s)
INT mode
EXT mode
Adjust.
(Observe the SYNC fall.)