Panasonic WV-NP1000 - Manual (Page 23)

23
Configure the settings relating to images and audio [Camera
setup]
The settings relating images and audio such as brightness and image quality of JPEG/MPEG-4 can configured on
this page.
The "Camera setup" page has 3 tabs of the [JPEG/MPEG-4] tab, the [Camera] tab and the [Audio] tab.
Configure the settings relating to JPEG image [JPEG/MPEG-4]
Click the [JPEG/MPEG-4] tab on the "Camera setup" page.
Configure the settings such as "Refresh interval (JPEG)", "Image capture size" and "Image quality" on this page.
Refer to page 24 for further information about the settings relating to MPEG-4 images.
[Refresh interval (JPEG)*]
Select an interval to refresh the displayed JPEG image
from the following.
0.1 fps/0.2 fps/0.33 fps/0.5 fps/1 fps/2 fps/3 fps/5 fps/
6 fps */10 fps */15 fps */25 fps *
Default: 5 fps
Note:
When "ON" is selected for "MPEG-4 transmission",
the refresh intervals may be longer than the set
value when the setting value with an asterisk (*) on
the right is selected.
When the selected resolution for "Image capture
size/resolution of JPEG" is "Full scan", the maximum
refresh interval for JPEG will be 12.5 fps and the
frame rate of the analog output will be 1/2.
[Image capture size/Scan mode]
Select the image capture size and the resolution of
JPEG from the following.
Partial scanning QVGA, Partial scanning VGA,
Partial scanning 960x720, Full scanning QVGA,
Full scanning VGA, Full scanning 1280x960
Default: Full scanning VGA
[Image quality]
Select image quality of JPEG images from the following.
0 Super fine/1 Fine/2/3/4/5 Normal/6/7/8/9 Low
Default: 5 Normal