Panasonic WV-NP1000 - Manual (Page 54)

54
Configure the settings on the "SPECIAL SETUP" page
[SPECIAL SETUP]
Configure the settings relating to image quality can be configured on the "SPECIAL SETUP" page. The settings can
be configured on the "SPECIAL SETUP" page.
Refer to the operating instructions (book) for descriptions of how to display the "SPECIAL SETUP" page.
SPECIAL SETUP page
[CHROMA GAIN]
Adjust the chroma level (colo
ur density).
Colo ur density will be incremented when the cursor is
moved to the "+" direction, and will be decremented
when the cursor is moved to the "–" direction.
Adjust the chroma gain while monitoring a vector colo
ur
scope or a colo ur video monitor.
[AP GAIN]
Adjust the aperture level.
Images will be sharper when the cursor is moved to the
"+" direction, and will be softer when the cursor is
moved to the "–" direction. Adjust the aperture level
while monitoring a colo
ur video monitor.
Note:
Moire fringes (vertical interference pattern) may
appear when shooting figures such in a carpet or
drapes. In this case, move the cursor to the "–"
direction to alleviate this problem.
[PEDESTAL]
Adjust the brightness of images.
Images will be brighter when the cursor is moved to the
"+" direction, and will be darker when the cursor is
moved to the "–" direction. Adjust the pedestal while
monitoring an oscilloscope or a colo
ur video monitor.
[PIX OFF]
Correct image defects (blemishes) such as scratches.
Up to 16 points can be corrected.
Refer to page 62 for descriptions of how to correct
defects.
[CAMERA RESET]
Reset the settings edited on the [Camera] tab to the
default settings.
Press simultaneously the [Left] button, [SET] button and
[Right] button for around 2 seconds after moving the
cursor onto "PUSH SW" of "CAMERA RESET". The set-
tings will be reset to the default settings.
**SPECIAL SETUP**
CHROMA GAIN ....
| ..160
AP GAIN ..... | .193
PEDESTAL ... | ...113
- +
PIX OFF
CAMERA RESET PUSH SW
RET TOP END