Panasonic KX-P8415 - Manual (Page 28)

28
* 1 Average life is based on an average of 5%
coverage of the printable area and standard
density for any one color (refer to Example A:
Monochrome 5% coverage). For the components
below, the average life may decrease depending
on the percentage of colors and coverage used.
For the detailed information of color imaging unit,
fuser unit and cleaning pad, see page 29.
B
Color imaging unit
B Fuser unit
B Toner cartridge
B Cleaning pad
* 2 If you print with high density when “Low <Color>
Toner” is displayed, you may get faded printout
before “<Color> Toner Empty” is displayed.
* 3 Specialty media (Transparencies, coated paper,
etc.) will result in shortening the life of each
consumable. When one page is printed on this
type of media, 2 pages are counted.
Do not insert the used oil supply roll into the new
fuser unit; it may damage the new fuser unit.
* 4 Using media except the recommended media
(see page 18) will result in shortening the life of
consumable.
* 5 When you have just replaced the transfer unit or
cleaning pad, you must reset the counter to 100%
remaining (see the each supply's manual).
Printer Components
Average Life Printer Components
60,000 pages Monochrome
15,000 pages Color
12,000 pages Black
10,000 pages Cyan,
Magenta,
Yellow
Toner cartridges * 1 * 2
60,000 pages
*
3 * 4
Fuser unit * 1
Oil supply roll (with cleaning pad)
Transfer unit * 5
15,000 pages * 3
80,000 pages
30,000 pages
15,000 pages * 4
Charge unit
Cleaning pad * 1 * 5
Example A
Color imaging unit * 1
Error Messages
For the detailed information on error messages,
refer to “Care and Maintenance” of the Operating
Instructions installed on your computer.
Oil supply roll
Fuser unit
Cleaning pad
Note when performing duplex printing:
Duplex printing will result in shortening the life of
fuser unit. When one sheet is printed, 2 pages are
counted per one side.
Monochrome
Color 7,500 pages