Panasonic KX-P8415 - Manual (Page 4)

Caution
This printer utilizes a laser. Use of controls or
adjustments or performance of procedures other
than those specified herein may result in
hazardous radiation exposure.
Warning
Make sure that the printer is installed in a well
ventilated room so as not to increase density of
ozone in the air. Since ozone is heavier than air, it
is recommended that air at floor level be ventilated.
The printer weighs approximately 49.2 k g {108.4
lbs.}. It must be handled by two people. Turn the
power off and remove the power cord when
handling the unit.
4
Ozone Release
Laser diode properties
Laser output : 5 mW max
Wavelength : 780 nm
Emission duration : Continuous
Warning
To prevent fire or shock hazard, do not expose this
product to rain or any type of moisture.
Caution
Do not open covers and do not attempt to repair the
unit yourself. Refer servicing to qualified personnel.
Warning
B
The power source voltage of this unit is listed on
the nameplate. Only plug the unit into an outlet
with the proper voltage.
B
When you operate this equipment, the outlet
should be near the equipment and accessible.
B
To ensure safe operation the AC cord supplied
must be inserted into standard three-prong AC
outlet which is effectively grounded (earthed)
through the normal wiring.
B
The fact that the equipment operates
satisfactorily does not imply that the power point
is grounded (earthed) and that the installation is
completely safe. For your safety, if in any doubt
about the effective grounding (earthing) of the
power point, consult a qualified electrician.
B If the plug cannot be inserted into the AC outlet,
contact a licensed electrician to replace the outlet
with a properly grounded (earthed) one.
B
Do not defeat the purpose of the grounding
(earthing) plug (ex. do not use a conversion
plug).
For Your Safety
General
Moving the Unit
Laser Safety
Power Source