Premio Computer Aries/Centella - Manual (Page 93)

Chapter 3
3-30
Set Supervisor/User Password
When you select this function, a message as below will appear on the screen:
Type the password, up to eight characters in length, and press <Enter>. The
password typed now will replace any previously set password from CMOS
memory. You will be prompted to confirm the password. Re-type the password
and press <Enter>. You may also press <Esc> to abort the selection and not
enter a password.
To clear a set password, just press <Enter> when you are prompted to enter the
password. A message will show up confirming the password will be disabled.
Once the password is disabled, the system will boot and you can enter Setup
without entering any password.
When a password has been set, you will be prompted to enter it every time you
try to enter Setup. This prevents an unauthorized person from changing any
part of your system configuration.
Additionally, when a password is enabled, you can also have BIOS to request
a password each time the system is booted. This would prevent unauthorized
8
Frequency/Voltage Control
Load Fail-Safe Defaults
Load Optimized Defaults
Set Supervisor Password
Set User Password
Save & Exit Setup
Exit Without Saving
CMOS Setup Utility - Copyright(C) 1984-2001 Award Software
8
Standard CMOS Features
8
Advanced BIOS Features
8
Advanced Chipset Features
8
Integrated Peripherals
8
Power Management Setup
8
PnP/PCI Configurations
8
PC Health Status
Esc : Quit F9 : Menu in BIOS
↑ ↓ → ← ↑ ↓ → ← ↑ ↓ → ← ↑ ↓ → ← ↑ ↓ → ←
: Select Item
F10 : Save & Exit Setup
Change/Set/Disable Password
Enter Password: