ParaBody GS2 - Manual (Page 21)

FIGURE 19
26
17
58
21
57
ADJUSTMENT
ADJUSTMENT
PULL AND
TWIST TO
DISENGAGE
• If upon completion of assembly, the HEAD PLATE (19) does not sit on top of the first WEIGHT PLATE (22), push the
HEAD PLATE (19) down, insert the WEIGHT SELECTOR PIN (51) and perform several repetitions at the press station.
This will relax the cable system and prevent the HEAD PLATE (19) from lifting up. See FIGURE 19
53
49
19
51
• If after completing previous step, the HEAD PLATE (19) still does not sit on top of the first WEIGHT PLATE (22) or if
there is excess slack in the cable system, adjust the threaded end of the LAT CABLE (20) and ADJUSTABLE GLIDE (53)
accordingly and retighten the jam nuts. See figure 19
• For maximum performance, the HEAD PLATE (19) should just barely sit on the top WEIGHT PLATE (22)
• Attach the LAT BAR (17) to the ball end of LAT CABLE (20) using one SNAP LINK (57) as shown in FIGURE 19.
• Attach the ANKLE STRAP (25) to the 12 LINK CHAIN (26) using one SNAP LINK (57) as shown in FIGURE 19
Thank you for purchasing the ParaBody GS2 Gym System. If unsure of proper use of equipment, call
your local ParaBody distributor or call the ParaBody customer service department at (800) 328-9714
STEP 19:
TIGHTEN
JAM NUT
SECURELY
25