Precor M9.20 - Manual (Page 14)

page 14
17. Align the electronic console mounting holes with the handrail clamp. Mount
the electronic console onto the handrail clamp by placing the two external
star washers (F) onto the two handrail clamp bolts (B). See Diagram 6.
Insert the bolts through the base of the handrail clamp and into the elec-
tronic console. Tighten the bolts securely with the hex key (H) provided.
18. Carefully push the excess cable up inside the handrail clamp compartment.
Check to be sure that the cable forms a smooth loop. If the cable is
pinched or damaged by improper installation, it will not be covered by the
limited warranty.
19. Insert the upper end of a handrail into the upper handrail clamp until the
black foam wrap just touches the clamp as shown in Diagram 7. Repeat
this step for the other handrail.
Note: Look underneath the handrail clamp and make sure that the
handrail ends meet in the middle of the clamp. Re-adjust the handrails,
if necessary.
20. Insert the three upper handrail clamp screws (C) into the upper handrail
clamp and finger-tighten. Do not tighten the screws more than finger tight
at this point.
Diagram 6 Attach electronic
console to
handrail clamp
Handrail clamp
Electronic console
Ribbon cable
Lift column
Diagram 7 Install
upper
handrails
Upper handrail
clamp
Trim strip
Electronic
console display
Upper handrail
Upper handrail
clamp
Cable tie & fastener
Ribbon cable