ProForm PFHS60070 - Manual (Page 11)

11
and 1/3 of the ÒNon-chlorine ShoxÓ bottle to the water
in the spa. Allow the water to circulate for five min-
utes. You should now test the pH level of the water.
Use the included test strips to check the pH of the
water. Refer to the instructions on the test strip pack-
aging to see how to use the test strips.
If the level is too low, add half of one of the ÒQUICK
pHix It UPÓ packets to the water. Let the water circu-
late through the spa jet unit for five minutes. Test the
pH level again. Repeat until the pH level is correct.
If the level is too high, add half of one of the ÒQUICK
pHix It DOWNÓ packets to the water. Let the water cir-
culate through the spa jet unit for five minutes. Test
the pH level again. Repeat until the pH level is cor-
rect.
Replace the spa cover and allow the water to contin-
ue to heat.
See WATER CHEMISTRY on page 13 for information
concerning proper water maintenance.
SECURING THE SPA COVER
The spa cover can be secured by snapping the latch-
es on the spa cover into the buckles on the side pan-
els.
The buckles can be
locked by inserting the
key and turning it
clockwise a quarter
turn. To unlock the
buckles, insert the key
and turn it counter-
clockwise a quarter
turn.
Always keep the buckles locked when the spa is
not in use. Keep the keys in a safe place, out of
the reach of children.
USING THE CONSOLE
Refer to the console diagram above. The function of
each console control is explained below:
Primer: This opening allows you to prime the spa jet
unit before operation (see PRIMING THE SPA JET
UNIT on page 10).
Thermostat: Controls the temperature of the water.
The water heats at about 1.7¡F an hour with the cover
on. The thermostat can be set to heat the water from
70¡F to 104¡F. Use a medical or other accurate ther-
mometer to check the temperature of the water.
On/Off: Turns the spa jet unit on and off. When you
first press the on/off button, the spa jet unit will run at
low speed, providing gentle hydrotherapy. Press the
button again and the spa jet unit will run at high
speed, providing more intense hydrotherapy. Press
the button a third time and the spa jet unit will shut
off.
The spa jet unit also features an automatic mode,
which heats and filters the water when the spa is left
unattended. When the spa jet unit is first plugged in,
or if the buttons on the console have not been used
for longer than twenty minutes, the automatic mode
will begin filtering or heating the water, as needed.
Note: to keep the filter and heat cycles from run-
ning, the power cord must be unplugged.
Air Control: Determines the amount of air that is in
the spa jet system during operation. If the control is
turned to the left, the amount of air flowing through
the jets will increase. If the control is turned to the
right, the amount will decrease.
DIAGRAM OF THE CONSOLE
Key
Latch
Buckle