ProForm PFHS60070 - Manual (Page 8)

8
1. Before beginning assembly, be sure that you
have read and understand the information in the
box above and on the previous page.
Unfold the Inflatable Spa Liner (9). Attach the nozzle
on the air pump to the valve on the side of the
Inflatable Spa Liner. Use the foot pedal on the air
pump to fill the sides of the Inflatable Spa Liner with
air.
Attach the nozzle on the air pump to the valve on
the floor of the Inflatable Spa Liner (9). Use the air
pump to fill the bottom of the Inflatable Spa Liner
with air.
Attach the nozzle on the air pump to the valve on
the top of the Inflatable Spa Liner (9). Use the air
pump to fill the cushion on the top of the Inflatable
Spa Liner with air.
2. Unfold the Fabric Spa Surround (8). Be sure that the
indicated flap is on the outside of the Fabric Spa
Surround. Insert the Inflatable Spa Liner (9) into the
Fabric Spa Surround. Align the valve in the Inflatable
Spa Liner with the hole in the Fabric Spa Surround.
Flip the flap on the Fabric Spa Surround (8) over the
low section of the Inflatable Spa Liner (9).
Be sure that all six cover buckles are fully inserted
through the loops in the Fabric Spa Surround (8).
3. Remove the power cord from the Spa Jet Unit (13).
With the help of a second person, place the Spa Jet
Unit (13) over the Fabric Spa Surround (8) and the
section of the Inflatable Spa Liner (9) which does
not have the cushion. Be extremely careful not to
tear the Inflatable Spa Liner (9) as you slide the
Spa Jet Unit into place.
2
9
8
Flap
Valve must
be visible in
this hole
1
ASSEMBLY
Before beginning assembly, carefully read the
following information and instructions:
¥ Assembly requires two people.
¥ Place all parts in a cleared area and remove the
packing materials; do not dispose of the packing
materials until assembly is completed.
¥ Assembly requires the included air pump.
¥ Read each assembly step before you begin.
¥ During assembly, make sure that all parts are ori-
ented as shown in the drawings.
9
Inflate here
third
Inflate here
second
Inflate here
first
3
8
13
9
Power
Cord