ProForm PFHS60070 User Manual
Page 12
12
SPA JET UNIT OPERATION
The spa jet unit features three hydro-therapy jets, a
whirlpool jet, a suction vent, and a filter housing.
The three hydro-therapy jets (A), located on the
front of the spa jet unit, focus the water massage on
your neck and back.
The whirlpool jet (B), located on the left side of the
spa jet unit, directs the flow of the water to create a
whirlpool action in the RESTORATION 600.
The suction vent (C),
located on the right
side of the spa jet
unit, pulls the water
into the spa unit, in
order to operate the
system. The suction
cover should always
be in place over the
suction vent. Never
operate the spa with-
out the suction
cover in place.
The filter (D), is locat-
ed on the left side of
the spa jet unit,
behind the filter cover.
The filter can be
removed for cleaning
and replacement by
removing the Filter
Cover and the two
filter cover screws and then pulling the filter from the
spa jet unit.
The spa jet unit features an automatic filter cycle and
freeze protection. If the spa jet unit has not been
operated for three hours, the pump will begin circulat-
ing the water for twenty minutes to filter any impuri-
ties. Also, if the water temperature falls below 40¡F,
the pump will begin circulating and heating the water
to prevent the water from freezing.
DRAINING THE RESTORATION 600
To drain the RESTORATION 600, you must use a
garden hose to siphon the water. Place one end of
the hose in the spa and hold it in front of a hydro-
therapy jet until there is a flow of water coming out of
the hose. Turn off the spa unit and unplug the
power cord. The unit will be damaged if it is run
without water circulating. Be sure the end of the
hose in the spa is on the floor of the spa.
DRAINING THE PUMP
After the RESTORATION 600 is drained (see DRAIN-
ING THE RESTORATION 600 above), the pump in
the spa jet unit should also be drained if the spa will
be stored for more than thirty days, or if it may be
exposed to freezing temperatures.
To drain the pump,
remove the spa jet
unit from the side pan-
els. Be careful not to
tear the inflatable
spa liner. Locate the
pump inside the spa
jet unit. Remove the
drain plug from the
pump. Tip the spa jet
unit slightly, until all the water has drained from the
pump. Replace the drain plug.
Drain Plug
Pump
A
B
D
C
C
Filter Cover
Screws
Filter Cover
D