Setting the voice mail tone, Voice mail service – Panasonic X-TSC14B User Manual
Page 36
“
Voice Mail Service
36
Setting the Voice Mail Tone
If your voice mail service sends a voice mail tone after a new message
has finished recording, set to “ON”. “
” icon will flash on the display if a
message was recorded in your mailbox. You will hear a series of voice
mail tones then a dial tone after lifting the handset or pressing
(SP-PHONE/HEADSET)
. (Contact your service provider about your service.)
Set to “OFF” when:
—you do not subscribe to a voice mail service.
—your voice mail service does not send a voice mail tone, or
—the unit is connected to a PBX.
Your phone comes from the factory set to “ON”.
Make sure that the handset is on the cradle, the AC adaptor is
connected and the SP-PHONE/HEADSET indicator light is off.
1
Press
(FUNCTION/EXIT)
.
2
Press
(_)
or
(^)
repeatedly until
“
VOICE MAIL TONE?
” is displayed.
3
Press
(fl)
OK/EDIT.
4
Press
(_)
or
(^)
to select the desired
line, “
LINE1
” or “
LINE2
”.
5
Press
(fl)
OK/EDIT (
NEXT
key).
6
Press
(_)
or
(^)
to select the desired
mode.
7
Press
(fl)
OK/EDIT (
SAVE
key).
≥
A beep sounds and the setting is saved.
≥
The display will return to step 2. To
program the other line, start from step 3.
To return to the standby mode, press
(FUNCTION/EXIT)
.
≥
You can exit the programming mode any time by pressing
(FUNCTION/EXIT)
.
11
:
50
AM
11
/
24
SAVE AUTO# ?
11
:
50
AM
11
/
24
VOICE MAIL TONE?
11
:
50
AM
11
/
24
LINE1
1
=NEXT
LINE 1
11
:
50
AM
11
/
24
LINE2
1
=NEXT
LINE 2
11
:
50
AM
11
/
24
ON
1
=SAVE
PQQX12879ZA-BM03 01.3.7 3:52 PM y [ W
36