Panasonic X-TSC14B - Manual (Page 47)

47
Useful Information
Problem
The unit does not display
the caller’s name and/or
phone number.
A caller called you, but the
caller’s information was not
recorded in the Caller List.
The display goes to the
standby mode while viewing
the Caller List.
(REDIAL/PAUSE) does not
function properly.
You cannot have a
conversation using the
optional headset.
Previously programmed
information is erased.
If you cannot solve your
problem
Remedy
≥ Other telephone equipment may be
interfering with your phone. Disconnect
it and try again.
≥ Other electrical appliances connected to
the same outlet may be interfering with
the Caller ID information.
≥ Telephone line noise may be interfering
with the Caller ID information.
≥ If you receive two calls at the same
time, only one of the Caller ID
information can be recorded.
≥ Do not pause for over 60 seconds while
searching.
≥ The button has a double function as
either redial or pause. It will redial the
last number dialed if pressed at the
outset of a call (p. 20). If another
number has been dialed first, it will
operate as a pause button (p. 40).
≥ Make sure that the optional headset is
connected properly (p. 43).
≥ Press (SP-PHONE/HEADSET) to make or
answer a call.
≥ If a power failure occurs, programmed
information may be erased. Reprogram
if necessary.
≥ Call our customer call center at
1-800-211-PANA(7262).
≥ Panasonic’s e-mail address for
customer inquiries:
[email protected]
for customers in the USA or Puerto Rico
ONLY
PQQX12879ZA-BM04 01.3.7 3:52 PM y [ W 47