Niles Audio MRZ-6 - Manual (Page 13)

Wiring Diagrams for Infrared Control
IR Connections for a System with a Dedicated Preamp/Receiver and one MRZ-6
As explained on page 6, a single zone system with one MRZ-6 will distribute the output of one Preamp/Receiver’s
selected audio source to each of its six outputs for amplification and individual volume control. See Figure 16.
• A 12V DC wall adapter is connected to the switched outlet of the Preamp/Receiver to provide sync (or
status) to the MRZ-6. This switched outlet may also be used to power up source components which have
latching power.
• Both ZONE DIP switches should be set to the UP (or single zone) position. All IR codes are passed through
both the MRZ-6’s Dedicated and Common flasher outputs.
• When using RP-9 keypads, all automation codes are taught to the MRZ-6.
For more information concerning IntelliPad®/MRZ-6 programming, see page 26 of the MRZ-6 manual.
11
0 1 0 : 0 0
O O : 0 0 O O : 0 0
93.9 FM
STEREO COMMON ZONE ALL ON
CTRL
OUT POWER
16VAC FLASHER LEVEL ADJUST
1
G
N
D D
A
T
A + 1
2
V
2
G
N
D D
A
T
A + 1
2
V
3
G
N
D D
A
T
A + 1
2
V
4
G
N
D D
A
T
A + 1
2
V
5
G
N
D D
A
T
A + 1
2
V
6
G
N
D D
A
T
A + 1
2
V
IN OUT
FLASHERS IR DATA DEDI- CATED 12V SYNC
IR SENSOR/KEYPAD INPUTS
V E
UART + -
MAIN
INPUT ROOM 1
OUTPUT ROOM 2
OUTPUT ROOM 3
OUTPUT ROOM 4
OUTPUT ROOM 5
OUTPUT ROOM 6
OUTPUT
L
R
L
R
L
R
L
R
CASCADE OUTPUT
L
R
L
R
L
R
L
R
Niles Audio Corporation, Inc.
Miami, Florida USA MODEL MRZ-6 This device complies with part 15 of the FCC Rules. Operation is sub-
ject to the following two conditions: (1) This device may not cause
harmful interference, and (2) this device must accept any interference
received, including interference that may cause undesired operation.
Figure 16 IR Connections for a System with a Dedicated Preamp/Receiver and one MRZ-6
To switched outlet
From tape or pre-out