Niles Audio MRZ-6 - Manual (Page 5)

Strain Relief Bar For All Connected Cables
A supplied steel bar attaches to the rear of the MRZ-6. By looping any cable around the strain relief bar before
you connect it to the MRZ-6, you relieve all strain on the cables. Now, anytime you move the MRZ, you move
the cables too, no more accidental disconnects.
Total Front-Panel Control
The front panel buttons of the MRZ-6 enable you to control ALL ON, ALL OFF, ROOM ON/OFF and VOL-
UME UP/DOWN. When entertaining family and friends, whole-house volume changes are easy and conve-
nient.
Single, Dual and Multi-Zone Capable
Multiple MRZ-6s can be configured into systems where all rooms listen to the same source or as multiple listen-
ing zone systems, where each MRZ-6 (up to 6 rooms) is connected to a dedicated source selecting preamp/receiv-
er creating a system where more than one source can be enjoyed simultaneously within the house.
Configurable Power With The Niles SI-1230
The Niles SI-1230 twelve channel amplifier enables you to configure the power for each area, selecting 15
watts per speaker (two speakers in mono fed from one channel), 30 watts per speaker (two speakers in stereo
each fed from a dedicated channel) or 80 watts per speaker (two speakers in stereo each fed from a pair of
bridged channels).
Compatible With Any Power Amplifier
The MRZ-6 is compatible with any power amplifier. As a result you may configure the power as your needs
dictate; a large amplifier for outdoor or critical listening areas and smaller amplifiers for small rooms or back-
ground areas.
Easy System Expansion
Up to six MRZ-6’s can be linked to control systems with up to 36 rooms. When linked, Global ALL ON or ALL
OFF commands affect the entire system. In addition, connected infrared controlled source equipment may be
controlled from any room with an IR sensor or IntelliPad.
Control Output
The 12V DC CONTROL OUT and an optional Niles AC-3 voltage-activated AC power switching system (Niles
stock# FG00242) enable your MRZ-6 to turn on and off components which do not have an IR command to
turn on and off (CD players, tape decks, power amplifiers etc.).
Confirm and Status LEDs
The CONFIRM LED flashes green when the MRZ-6 receives any IR command. The ROOM STATUS LEDs light
green when a room module is turned on. When a green ROOM STATUS LED blinks the corresponding room
module is “selected” and ready to be controlled.
Room Identification Labels
Recessed areas above the ROOM STATUS LEDs and buttons accommodate room identification labels enabling
you to custom label each room. Seventy-two adhesive-backed room labels are included with your MRZ-6.
Proudly Made in the USA
The MRZ-6 is made in Miami, Florida and comes with a limited two year parts and labor warranty.
3