Niles Audio MRZ-6 - Manual (Page 27)

25
Controlling The MRZ-6 Using Its Front Panel
Turning a Room On and Off
• Press the ROOM SELECT button(s) of the room(s) you wish to control. Its corresponding ROOM LED(s) begins
to blink, indicating the room(s) has been selected and is ready to be controlled. It has not been turned on or
off yet!
• Press the ON/OFF button to toggle between the room’s on/off status. This command will affect all rooms that
are selected (blinking). If multiple rooms with varying on/off status are selected, the first room selected will
determine if all selected rooms will toggle on or off.
• When a room is turned on, the ROOM STATUS LED stays on. When a room is turned off the LED turns off.
• When a room is turned on, the initial volume level is determined by the V DIP switch setting on the rear
panel of the MRZ-6 (for more information see page 19). As the MRZ-6 adjusts the volume of a room, the front
panel room LED will flicker.
Using the ALL ON Command
• Pressing the ALL ON command will turn on all rooms that have been enabled by the ALL ON DIP switches
on the rear panel of the MRZ-6 (for more information see page 19).
• The ALL ON command can be linked to other MRZ-6’s via the UART connector to turn on enabled rooms
system-wide (for more information see page 20).
• When all the rooms turn on, the initial volume level is determined by the V DIP switch setting on the rear
panel of the MRZ-6 (for more information see page 19). As the MRZ-6 adjusts the volume of a room(s), the
front panel room LED will flicker.
Using the ALL OFF Command
• Pressing the ALL OFF command will turn off all rooms and turn off the preamp/receiver.
• The ALL OFF command can be linked to other MRZ-6’s via the UART connector to turn off all rooms
system-wide (for more information see page 20).
Controlling a Room’s Volume
• Press the ROOM SELECT button(s) of the room(s) you wish to control. Its corresponding ROOM LED(s) begins
to blink. This indicates the room(s) has be selected and is ready to be controlled.
• Pressing the VOLUME UP or VOLUME DOWN button adjusts all selected rooms. As the MRZ-6 adjusts the
volume of a room(s), the front panel room LED will flicker.
• If a selected room is off, pressing the VOLUME UP button will first turn the room on to its lowest volume set-
ting and then incrementally raise the volume.