Netcom NB9 - Manual (Page 40)

0 NB9/NB9W ADSL+ VoIP Router
YML790 Rev8
MANAGEMENT
Management > Device Settings > Backup
Backup enables you to save a copy of the NB9/NB9W configuration file. This can be re-loaded to restore
your settings should you need to reset the device to its factory defaults. Click on “Backup Settings” button to
start the backup process.
The default file name is backupsettings.conf, or give it an explanatory name (e.g. NB9WHome.conf) and save
it to somewhere safe on your computer. Click on “Backup Settings” button to start the backup process.
Management > Device Settings > Update
The Update option under ‘Management > Device Settings’ enables you to load a previously saved
configuration file. Click on browse, navigate to the .config file and then click on update settings to restore
settings.
Management > Device Settings > Restore Default
Clicking the ‘Restore Default Configuration’ button in the Management > Restore Settings screen will restore
the original factory default settings on your NB9/NB9W.
Note 1: This entry has the same effect as the hardware reset-to-default button on the rear of the NB9/NB9W. The NB9/NB9W hardware and
the boot loader support the reset to default button. If the reset button is continuously pushed for more than 5 seconds, the boot loader
will erase the entire configuration data saved on the flash memory.
Note 2: Restoring system settings requires a system reboot. This necessitates that the current Web UI session be closed and restarted.