Newer Technology NWTMANMSV25ASSY - Manual (Page 4)

4
Hard Drive Installation
Please observe all static
safety precautions
before proceeding.
Before removing any electronic
component from its protective
anti-static bag, you should safely
discharge any excess static elec-
tricity. A simple way to do this is
by touching a grounded piece of
metal, such as the metal cover of
your computer’s power supply
or a water pipe.
Begin by removing the four Phillips screws from the bottom 1.
of the Newer Technology miniStack v2.5 enclosure. Remove
the drive carrier from inside of the enclosure.
Place your 3.5” SATA hard drive onto the mounting bracket as 2.
shown. The connecting cables need to be positioned to the
left, with the opening in the drive bracket to the top. Once
inserted properly into the bracket, insert the four included
screws to fasten it securely.
Make sure your hard
drive is attached to the
heat sink in the same
manner as illustrated.
Attaching it incorrectly will
result in your hard drive being
unable to fi t properly into the
enclosure.
5
1.
2.
3.