Newer Technology NWTMANMSV25ASSY - Manual (Page 5)

4
1.
2.
5
Place the drive and bracket inside the enclosure, routing the 3.
power and data cables to avoid pinching them.
Take the black and white wire at the upper right of the enclosure 4.
in this picture and tape the thermal probe (the blue portion of
the wire) onto the center of the hard drive using the enclosed
piece of yellow Kapton tape as shown.
Once the hard drive is inserted, replace the four Phillips 5.
screws on the bottom of the enclosure to fully secure the
drive carrier. Make sure that all wires are as fl at as possible
and place the plastic top back onto the miniStack enclosure.
Before continuing, make sure that there are no bulges in the
top cover.
Make sure the hard
drive and heat sink are
fully inserted into the
enclosure.
Otherwise, you will not be able
to put the top panel on prop-
erly, nor secure the heat sink
with the four Phillips screws
you removed in Step 1.
The thermal probe
helps to regulate the
fan speed.
Failure to attach the thermal
probe can result in drive
overheating, leading to possible
data corruption and loss!