NEC LT280 - Manual (Page 17)

15
Setting the LAN Setting of Projector
5. Setting the LAN Setting of Projector
5
5-2. Wireless LAN
When inserting the wireless LAN card into the PC card slot of the projector, configure the LAN
settings in the “PC Card” page of “LAN Mode” selected from On-Screen Menu.
■ Flow of Setting
Setting of "Network Type".
Select SSID in "Site Survey".
Input "SSID" (if necessary).
Select "Mode" (if necessary).
Select "Channel" (if necessary).
Setting of "WEP"
Select the number of bits of "WEP".
Select "Key Select".
Set "Key 1 to Key 4".
If "Easy Connection" is selected
8
8
9
10
11
12
13
14
15
16
16
1
3
Step Display "PC Card" page of "LAN Mode".
4 Step Input "IP Address".
2 Step Select "Profiles".
5 Step Input "Subnet Mask".
6 Step Input "Gateway".
7 Step Input "DNS Configuration".
17 Step Finalize "Advanced".
18 Step Reconnect the network.
19 Step Finalize the setting.
Step - Setting of "Advanced".
Step Enable or disable "DHCP".
If "Disabled" (without check mark)
If "Enabled" (with check mark)