NEC LT280 - Manual (Page 26)

24
5. Setting the LAN Setting of Projector
5-3. Wired LAN
When connecting a LAN cable to the LAN port of the projector, configure the LAN settings in the
“Built-in” page of “LAN Mode” selected from On-Screen Menu.
■ Flow of setting
1
3
Step Display "Built-in" page of "LAN Mode".
4 Step Input "IP Address".
Input "Subnet Mask".
Input "Gateway".
2 Step Select "Profiles".
5 Step Input "DNS Configuration".
6 Step Reconnect the network.
7 Step Finalize the setting.
Step Enable or disable "DHCP".
If "Disabled" (without check mark)
If "Enabled" (with check mark)