NEC LT280 User Manual
Page 23
21
Setting the LAN Setting of Projector
5. Setting the LAN Setting of Projector
5
13
Select “WEP” page (if necessary).
Proceed to step
17
if WEP is not set.
<1> Use the
SELECT
̄
/
̆
button to select the “Network Type” tab, and press the
button to highlight the “WEP” tab.
The “WEP” page will be displayed.
14
Select “WEP”.
Select whether WEP (encryption) is performed or not.
To perform WEP (encryption), set an encryption key.
• Disable ................... WEP (encryption) is not performed. There is a danger that the contents of
communication are monitored.
• 64 bit ...................... 64-bit data is used as an encryption key of WEP.
• 128 bit .................... 128-bit data is used as an encryption key of WEP.
• 152 bit .................... 152-bit data is used as an encryption key of WEP.
Security is reinforced as the number of bits is increased.
15
Select “Key Select” (only when WEP is selected).
If “64 bit”, “128 bit”, or “152 bit” is selected from “WEP”, select which of the following encryption keys,
“Key 1” to “Key 4”, is to be used.