NEC GT2150 - Manual (Page 17)

E – 7
REM
OTE 1
PC CO
NTR
OL
REMOTE
2
AC IN
SC, TR
IGG
ER
OU
T
OU
T
IN
IN
PC C
ARD
3
5
4
1
7
8
9
2
6
1. PC CONTROL Connectors (Mini D-Sub 9 pin)
For system expansion such as PC-Control.
IN:
connect to the external equipment such as PC.
OUT: for daisy-chaining multiple projectors and operating them with
the same external equipment. To do so, connect to a second
projector’ s IN terminal to relay the input at the IN terminal of the
first projector until all the projectors are connected.
2. REMOTE 1 Connector (Mini D-Sub 15 pin)
This terminal allows external control of the projector from either the
Switcher or from an external control. When the Switcher is used, con-
nect to the REMOTE 1 terminal on the back of the Switcher.
NOTE: This projector is compatible with the ISS-6020 Switcher.
3. REMOTE 2 Mini Jacks
IN: wired remote control input.
OUT: for daisy-chaining multiple projectors and operating them with
the same remote control. To do so, connect to a second projec-
tor’ s IN terminal to relay the input at the IN terminal of the first
projector until all the projectors are connected.
4. SC. TRIGGER Mini Jack
Screen Trigger- When the GT2150 is powered ON the screen trigger
output sends a low voltage trigger to the screen controller and the
screen will go down.
Front Terminal Panel (Left)
When the GT2150 is powered OFF the screen trigger stops sending a
low voltage trigger to the screen controller and the screen will go up.
NOTE: Screen Controllers are supplied and supported by screen manufactures.
This option is not included with the GT2150 projector.
NOTE: Do not use this jack for anything other than intended use. Connecting
the wired remote control to the SC. TRIGGER Mini Jack causes damage to the
remote control.
5. Slot for LAN Board (Optional)
Use this connector to control the projector on a LAN. The optional LAN
kit is required when this connector is used. See the instructions in-
cluded with the optional LAN kit (GT50LAN).
6. AC IN
Connect the supplied power cable’s three-pin plug here.
Three types of power cable are supplied with this LCD projector: three-
pin type for U. S. A. and Canada. Two-pin type for Europe and Japan.
7. PC Card Slot
Insert a CompactFlash™ card here.
8. PC Card Eject Button
Press to eject a CompactFlash™ card.
9. PC Card Access Indicator
Lights while accessing a CompactFlash™ card.
Tip (12V)
Ring (0V)
Sleave (ground. 0V)
Stereo mini cable
(not supplied)
Inserting or Ejecting a CompactFlash Card
CAUTION: DO NOT EJECT THE CompactFlash CARD, TURN
OFF THE POWER, OR UNPLUG THE POWER CABLE of the
projector while the PC card access indicator light shows that data
is being accessed. Doing so could cause damage to the
CompactFlash card.
Inserting
Insert the CompactFlash card into PC Card Slot with its TOP FAC-
ING DOWN.
IN
IN
PC CARD
PC C
ON TRO
L
REM
OTE
2
IN
IN
PC CAR
D
Bottom
Removing
Press the PC Card Eject button. The CompactFlash card ejects
partially, then remove.