NEC GT2150 - Manual (Page 58)

E – 48
Message:
You can choose the desired information to be displayed on the
screen.
No Input: This option turns on or off the "No Input" message to be
displayed in the top right corner on the screen.
On ................ The message will be displayed.
Off ................ The message will not be displayed.
Clean Filter: This option turns on or off the "Please clean the filters"
message each time you turn on the projector if the projector has
been used in excess of 100 hours of use.
On ................ The message to clean the filters will be displayed.
Off ................ The message will not be displayed.
See page E-53 for cleaning the filters. After cleaning the filters, re-
set the filter usage back to zero.
To reset the filter usage, see page E-50.
Direct Button:
Volume Bar: This option turns on or off the volume bar when you adjust
the sound volume using Select
▲▼ button on the remote control.
On ................ You can increase or decrease the sound volume with the vol-
ume bar on screen.
Off ................ You can increase or decrease the sound volume without hav-
ing to use the volume bar.
Keystone Bar: This option is avaiable on the optional remote control
only. This option turns on or off the keystone bar when you adjust the
keystone using KEYSTONE +/- button on the optional remote control.
On ................ You can increase or decrease the level with the keystone bar
on screen.
Off ................ You can increase or decrease the level without having to use
the keystone bar.
[Page 3]
Setup
Enables you to set operating options.
Press "OK" to save your changes for all the features of Page1, Page2,
Page3, Page 4, Page5 and Page 6.
[Page 1]
[Page 2]
Display Select:
You can choose the desired status information to be displayed on the
screen. The desired status information will be displayed each time you
switch between sources.
Date Format:
Eight display formats can be selected. This date format sets the cur-
rent date that appears on the upper left corner of the screen.
Date, Time Preset:
Setting the Current Date and Time
You can set the current time, month, date, and year.
1. Type in date.
Enter month, date and year in this order using INPUT buttons on the
remote control.
Month and date must be entered in two digits. For example, to display
"February", press "0" and "2".
2. Type in time.
Time is expressed in the 24-hour format. For example, 6:00 p.m. is en-
tered as 18:00.
3. Select "OK" and press ENTER.
Closing the window allows the clock to start.
The current year, month, date and time are displayed on the top of the
screen.
NOTE: The projector has a built-in clock. The clock will keep working for
about 3 days after the main power is turned off. If the main power is off for
3 days or more, the built-in clock will be reset. If the built-in clock is reset,
set the date and time again. The built-in clock will not reset while in the
standby condition.